PF10000146233
In stock
Banfluxion Glue Free Stretch Frame Screen Silk Screen Printing Mesh Stretching No Glue Self-Tension Frame Stretch Screen Tool, 20x16 inch
$83.00
- 【Premium Material】: The glue free stretch frame screen applies to quality steel plate and aluminum profile, which has advanced electrostatic spraying treatment so that the frame is easy to clean, hard to deform and durable. The stretch screen tool can be repeatedly stretched and printed hundreds of times for achieving the effect of one frame to one hundred frames.
- 【Convenient and Efficient】: The glue free self-tension stretch frame need not to be stretched and its tension can be up to 20N. Compared with other ordinary frame, the no glue self-tension frame just needs 5 minutes to stretch the mesh. Moreover, the frame does not need any glue, so it will protect environment at some extent.
- 【Easy to Use】: The silk screen printing mesh is easy to operate. It does not need stretcher and brush the mesh glue. It will take 5 minutes to stretch the frame, which is one tenth of the ordinary frame. In addition, the mesh can be directly installed in the screen frame to print.
- 【Reusable and Detachable】: The mesh could be detachable after print. Users could clean and save it after use. When the pattern needs to be printed again, the mesh could be installed on the frame.
- 【Parameter】: Frame outer size: 19x23 inch; Frame inner size: 16x20 inch; The pattern size should be within14.17x18.11 inch. The outer dimension of the plate mesh is 19.3x23.22 inch.
This product is fulfilled by seller
Install the mesh:
- Loosen four screws and align the inner edge of the aluminum pressure slot with the inner edge of the frame.
- Use aluminum alloy pressure mesh bar to wire mesh buckle into one side of the aluminum tank, straighten the mesh as far as possible , in the opposite side , wire mesh buckle into the alumi- num tank; Then buckle mesh into the other two sides.
- First use the hand electric drill to alternately turn the four screws, and then tighten the mesh .
- If the tension is not enough, use the reinforced inner hexagon wrench to continue to tighten the tension.
- Before printing, the foamed rubber strip can be inserted between themesh and the frame . the edge can be sealed with tape.
Special tips:
- installation of the plate, because the force is not uniform, may cause a slight deformation of the pattern; If you need to correct, you can paste the original film or 1:1 printed copy on the plate, and then align the screen pattern with the original copy by fine-tuning the four-side screw of the screen frame.
Detach the mesh:
- Evenly loosen the four side screws of the mesh frame.
- Use the open cover handle to insert the horizontal edge of the aluminum alloy batten.
- Lift the handle to open the batten easily.
- Detach the mesh and save it.
| Brand Name | Banfluxion |
|---|---|
| Part Number | CB-006073 |
Write Your Own Review
0
% response rate, 0
-mins response time